• Keep up to date with Ausbb via Twitter and Facebook. Please add us!
  • Join the Ausbb - Australian BodyBuilding forum

    If you have any problems with the registration process or your account login, please contact contact us.

    The Ausbb - Australian BodyBuilding forum is dedicated to no nonsense muscle and strength building. If you need advice that works, you have come to the right place. This forum focuses on building strength and muscle using the basics. You will also find that the Ausbb- Australian Bodybuilding Forum stresses encouragement and respect. Trolls and name calling are not allowed here. No matter what your personal goals are, you will be given effective advice that produces results.

    Please consider registering. It takes 30 seconds, and will allow you to get the most out of the forum.

Prefered Internal Power Rack Dimensions?

BrisVegasGhost

BrisVegasGhost

Elite Member
I'm knocking up my own power rack and just needed some info on the internal depth that is preferred.
I was considering 1000mm internal. I think some racks I have used have been anything from 700mm to 1000mm.
I prefer a bit more room in a rack personally.
If anyone has a rack that they can measure the depth internally would be appreciated.
Cheers,
 
Deeper the better IMO.
I'd just go as wide as your bar allows and make it square though
 
also depending on your height restrictions where you plan on putting it i'd go as high as you can so you can OHP inside the rack and also hang rings and use them with some extra space
 
My width will be 1200... This will give me 45mm clearance either side to rack the barbell. So might look at making the depth the same.
Cheers
 
You must log in or register to reply here.
Top