• Keep up to date with Ausbb via Twitter and Facebook. Please add us!
  • Join the Ausbb - Australian BodyBuilding forum

    If you have any problems with the registration process or your account login, please contact contact us.

    The Ausbb - Australian BodyBuilding forum is dedicated to no nonsense muscle and strength building. If you need advice that works, you have come to the right place. This forum focuses on building strength and muscle using the basics. You will also find that the Ausbb- Australian Bodybuilding Forum stresses encouragement and respect. Trolls and name calling are not allowed here. No matter what your personal goals are, you will be given effective advice that produces results.

    Please consider registering. It takes 30 seconds, and will allow you to get the most out of the forum.

Width of bench

The Hamburgler

The Hamburgler

Spotter Loader
Hey I was just wondering if anyone could tell me the width of a typical powerlifting bench?
Looking at getting one for my birthday in a couple of months and just wanted to make sure I end up getting one that I don't roll off (like my current flat bench).

30cm rings a bell but I'm not 100% sure
 
Hey HB,

From the ipf rule book:

Bench
[FONT=Times New Roman,Times New Roman][FONT=Times New Roman,Times New Roman]The bench shall conform to the following dimensions:
1. Length - not less than 1.22 m and shall be flat and level.
2. Width - not less than 29 cm and not exceeding 32 cm.
[/FONT][/FONT][FONT=Times New Roman,Times New Roman][FONT=Times New Roman,Times New Roman]3. Height - not less than 42 cm and not exceeding 45 cm measured from the floor to the top of the padded surface of the bench without it being depressed or compacted. The height of the uprights, which must be adjustable, shall be a minimum of 75 cm to a maximum of 110 cm measured from the floor to the bar rest position.
4. Minimum width between insides of bar rests shall be 1.10 m.
5. The head of the bench shall extend 22 cm beyond the center of the uprights with a tolerance of 5 cm either way.

Not sure of other feds.. ?
[/FONT][/FONT]
 
Cheers.

I think it's pretty standard give or take a cm between feds.
Pretty sure my current one is like 26/27cm wide lol
 
You must log in or register to reply here.
Top